The first picture shows two separate pieces so you can see the full frontage of each face
This mold will make a Wood Spirit (Green Man) face on one side of the piece and the other side will have the face of Pan (Fawn), I believe the goat man was called PAN by the Greeks and FAWN by the Romans
The finished piece is approximately 3 1/4" tall on the PAN side due to his hair that comes above the top of the tree
the piece is approximately 3" wide at the base, at the widest part
Approx weight of my wax sample is
5.7 ozs.
Your weight will depend upon
the wax you use
This may be a slit mold
see the link at the top of my listing CUTS/SLITS
Penguin Love Molds are proprietary and can NOT
be duplicated or reproduced
see terms of sale prior to purchase
Please allow ample time to pour and cure your custom mold prior to shipping, please email with any questions prior to purchase
Not FDA approved for food use
Smoke Free Environment
PenguinLoveMolds
Silicone can withstand temps
in excess of 300 degrees
My molding process eliminates
the air in Silicone which
produces a far superior finished product
International Buyers email for payment options and shipping cost before purchase
See other payment/shipment options below
Summary of PENGUIN LOVE Selling Policies
U.S. Buyers
PayPal Payment MUST be received within 7 days of auction close
International Buyers
Payment by PayPal Current International rates prevail with insurance and handling charge. Payment must be received within 7 days of auction close.
Shipping
United States Priority Mail, includes Delivery Confirmation unless otherwise posted. ~ International Priority Mail
Combined Shipping
Highest priced mailing first then mailing discount for each additional item purchased, if mailed together in the US
Returns
Material Flaws Only ~ See full return policy link at the top of the page
Tips
1) Split Molds are common, use a rubber band to hold the mold together while pouring your product
2) Use a damp/moist paper towel to rub out any imperfections on your finished product
3) First roll a small amount of product into your mold to get into the deep crevices of the mold, this will help eliminate air that can get trapped